Underfloor Heating Manifolds:Intelligent Control Manifold
Thermo Actuators: Opens and shuts valve on each group. It is controlled by the room sensor in each controllable area via the wiring centre, there maybe more than one group/actuator per room sensor. If the manifold is serving one area it maybe that there are no actuators supplied and the whole manifold is controlled via a motorised valve with no wiring centre.
Auto Air Eliminators: Removes unwanted air from the system. The air eliminators must be shut off once all the air is out of the system. Failure to do so could result in them letting by water (This will invalidate the system guarantee)
Fill/Drain points: Used when filling and testing, also for maintenance.
Pressure/Temperature Gauge: Shows flow temperature and system pressure.
Flow Meters incorporating Balancing valves: Shows the flow rate through each group of pipe in litres per minute. By removing the red locking cap, the plastic indicator tube can be turned to set the required flow rate.
Return Manifold Block: Connects to the return side of the heating system.
Flow Manifold Block: Connects to the flow side of the heating system.
| INTELLIGENT CONTROL RANGE |
