WLOC

WLOC Outside temperature sensor
The rate of heat loss from any building is governed by the temperature difference from inside to out. By using the outside sensor, the supply water temperature to the system is constantly and automatically adjusted to give the most efficient and optimum control.

Begetube UK has always promoted the use of weather compensated controls. The Intelligent control uses this feature along with self learning room sensors to provide the most comprehensive underfloor heating control system available in the UK today.

If you have a full system master control box (WLM-1FS) an outside air sensor (WLOC) will have also been specified and supplied. The outside air sensor is wired into the 5 Volt bus system the same as all the room sensors. This gives the system the ability to provide a compensated flow temperature to the underfloor heating circuits further enhancing the overall operation. This sensor should be fitted on an outside north facing wall ensuring that it does not receive direct sunlight. Also ensure that this sensor is not fitted close to any other heat sources ie. flue outlets, bathroom extract vents or exterior halogen lamps.

WLTD Sensor with setting mode and limit sensor

WLTP Tamperproof sensor

WLCT Clock sensor

WLTA Sensor with ± 4°C local adjustment